Search the forum,

Should be alright for a while......

Post new thread

Discuss Should be alright for a while...... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
turnpin

turnpin

Esteemed
Plumber
Subscribed
Messages
5,493
If we were to be snowed in lol .......anyone else's Mrs tend to over do it and the complain about weight gain over the holidays....regards Turnpin:smile5: P_20161224_184549.jpgP_20161224_184555.jpg
 
Status
Not open for further replies.

Reply to Should be alright for a while...... in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
219
mutley racers
M
M
Central heating losing pressure all the time
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
2
Views
214
PSxxxxxx
P
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
267
Chuck
C
K
Running copper pipework above / across a Gas boiler?
Hi all, this is probably a daft question but I need to run my cold feed from one side of my wall mounted boiler to the other. Running it beneath the boiler is difficult with lots of obstacles, is it okay if I run soldered copper over / across the top of the boiler? It'll be about 4" off the top...
Replies
2
Views
127
kristeva
K
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
240
DIwhYdidIstartThis
D
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Contractor Forum
DIY Forum
Tiling Tools
Tile Forum
Tiling Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock