Search the forum,

Discuss Grasslin Ecosave problem in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
C

czgreen

Hi there, I have a range tribune he boiler and it's controlled by a grasslin ecosave. I've never had any problem with it before but now it's broken. It has two indicators an off peak one which comes on during the night when the off peak timer is set to heat up the water. There is also a boost indicator. i can put on a boost for between 15 to 120 mins if necessary and the boost indicator comes on when I do. The last few days the boost indicator has been on constantly, I'm worried this means my boost has been on constantly as well and my electricity bill will be huge. Normally to set a boost you put it to the time you want and press it in, if you want to interrupt it or stop it you just press it in again. Can anyone help?
 
Get it replaced for a Horstmann - Economy 7 Timer,last so much longer and far better unit,if faulty and sticking on,you should get repaired asap for your safety

if booster stuck on ,you will be facing higher bills,however immersion heater will not be on all the time as it has a built in thermostat that turns off when water temp reached,cheap rate immersion maybe ok,just clock stopped working as it does on this model

imho
 
Hi, thanks for the reply. If I'm just replacing the timer unit and not the boiler do I need to call a plumber or an electrician?
 
Many plumbers cover this,you would have to check when you ring them,or you could just contact a electrician

imho
 
Status
Not open for further replies.

Reply to Grasslin Ecosave problem in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
117
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
107
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
184
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
241
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
317
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock