Search the forum,

Discuss baxi conbi 105e in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
1,590
can you get a kit for differential on diverter valve,rod not coming out when dhw or ch is called for
 
gasman is your man for this although I am pretty sure you can buy the parts but it the part numbers which make it confusing
 
you will need the primary(small) kit posted in poxis reply ,assuming your looking at the rear primary flow switch desrob
 
you will need the primary(small) kit posted in poxis reply ,assuming your looking at the rear primary flow switch desrob
ethe small one at the rear,can i just ask regarding the sequence of the micro switch on this diverter does the rear (small one)activate on both dhw and ch
 
ethe small one at the rear,can i just ask regarding the sequence of the micro switch on this diverter does the rear (small one)activate on both dhw and ch
yes it does its also vital you check the small hole under the diaphragm they can block with crud
 
make sure you have a 8mm spanner with you its much easier to undo the small pipenut and a needle for unblocking the hole plus of course the new diaphragm
i did this yesterday,,all was well till about 4 30 today,boiler will not fire in either ch or dhw,but when i operate micro switch the boiler fires
 
i did this yesterday,,all was well till about 4 30 today,boiler will not fire in either ch or dhw,but when i operate micro switch the boiler fires
just thinking if the pump is not creating enough pressure through diverter would this create this fault
 
Status
Not open for further replies.

Reply to baxi conbi 105e in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Recently had a Viessmann Vitodens combi boiler installed, quite often when the adjacent cold mixer tap is opened the boiler starts for a few seconds! Can anyone tell me what is causing this? And how to cure?
Replies
3
Views
216
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
242
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
353
Hi. I need a new toilet supply line but don’t know the size type of the fitting at the shut off valve. It is not 3/8 compression. It is a plastic nut about the same size as the one going into the cistern but has a different thread. Attached is a photo. Can you advise. Thanks.
Replies
2
Views
198
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
253
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock