Search the forum,

Discuss Boiler choice?? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Messages
18
I have worked out a heating/hot water system to need a 35kw boiler but I am not sure which is the one to go for. Has anyone got any suggestions for the best system boiler to go for? The old boiler has the pump internally fitted so obviously it would be easier for this to be the same in the new boiler.

I value anyone's opinion

Cheers
 
Decide how much you want to spend and have a look around.this is the million dollar question, preference of differant installers as well differant features make this difficult.
Valliant,veissmann,baxi,remeha(broag) all good makes
good luck
 
choose your local plumber first, and ask his advice, then ask another local plumber.
some of the above options are good options.
dont buy a boiler because you are told it has a 5 year guarantee - do lots of research.
there are plenty of old "which boiler" threads on here, have a read through them
 
How big is the house!!If that is 35 kw for heating then it must be a mansion!

How did you work out that figure?

Graham
 
How big is the house!!If that is 35 kw for heating then it must be a mansion!
The OP did say it was for a "heating/hot water system", so he might be thinking of a combi boiler.

Even so, the heating requirement should also be determined to make sure the proposed combi can modulate down to that level and preferably well below.
 
Status
Not open for further replies.

Reply to Boiler choice?? in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hello, I am seeking some advice, I have a POTTERTON PROMAX 28 COMBI Boiler and I noticed yesterday that the water around the house is no longer warming up. The heat exchanger has been changed 6 months ago, so I do not believe it is that. Does anyone have any ideas on what it could be? Thanks
Replies
4
Views
219
  • Question
Ideal Logic 24, Previous problem was that the hot water was only cold or barely warm if the heating was in use. If heating was off and boiler cold then would get hot water most of the time. Changing the flow cartridge about 2 years ago (when I moved in) solved this problem enough to suffer it as...
Replies
2
Views
113
Every two weeks or so I have to go and top up the system because the hot taps are running cold. Boiler display is flashing 0.6 bar and I fill up to 1.3. I've had an engineer look inside the boiler and he can't see anything wrong. I've checked the pipes all over the house and cannot see any...
Replies
1
Views
112
Hi everyone, Looking for a bit of advice, recently went to a job where heating was operating when called for however not for the hot water. I have changed the 3 port actuator Honeywell head however this doesn’t seem to have solved the issue, does this mean that the programmer is faulty? Or is...
Replies
8
Views
238
Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
281
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock