Search the forum,

Unvented direct cylinders, whats the best?

Post new thread

Discuss Unvented direct cylinders, whats the best? in the Ireland area at PlumbersForums.net

R

rikpal

Gas Engineer
Messages
17
Looking at getting an unvented cylinder fitted, looking for any feed back on the diffrent brands, good bad etc.
Thanks
 

Reply to Unvented direct cylinders, whats the best? in the Ireland area at PlumbersForums.net

Similar plumbing topics

B
Unvented hotwater cylinder
Fitted unvented hotwater cylinder building control looking forms signed it off job was in england i am qualified northern ireland send out a form to fill in what do u need to sign off in england as building control said they dont give out forms like they do in northern ireland
Replies
4
Views
209
ShaunCorbs
ShaunCorbs
M
Viessmann external flue run conundrum
Hi all. Hope you have all been keeping well. A while back I decided I only wanted to fit one brand of boiler and decided on Viessmann due to space for servicing and changing parts if ever needing to. I am finding my decision rather hard due to the different clearances on flue runs and cupboards...
Replies
9
Views
216
mutley racers
M
D
Covering shallow sewer pipe under concrete Patio
Hello all, I’m replacing a concrete paving slab patio in the back yard. The original patio used 50mm deep concrete slabs on hardcore & sand. I’m planning to pour a 100mm deep concrete patio on 100mm hardcore. In order to achieve the same final height to line up with the rest of the patio, I...
Replies
6
Views
250
DIwhYdidIstartThis
D
sammie81116
Sewer pipe problems not sure about it
Hi all Noticed bad smell in my drain out side put my hand down and it unclogged it for now however I checked my sewer drain and after flushing my toilet a good few times nothing is going to the sewer so don't know is there a blockage or what way it works many thanks and advice would be grateful
Replies
3
Views
532
Chuck
C
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
1
Views
207
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Tiling News
Tiling Advice
Tilers Talk
Tile Blog
Electrical Forum for Electrical Advice
Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock