Search the forum,

Gledhill inlet control valve leaking on pressurised system

Post new thread

Discuss Gledhill inlet control valve leaking on pressurised system in the Plumbing Jobs | The Job-board area at PlumbersForums.net

C

Chipdoctor

Messages
30
The plug on the opposite side of the red cap with 4.5 is leaking. I have tried tightening it but unsuccessful.
My postcode is BA3 4JL, west of Radstock in Somerset. Hopefully a plumber would like the job - social distancing guaranteed during the job!
[automerge]1587214286[/automerge]
Chipdoctor said:
The plug on the opposite side of the red cap with 4.5 is leaking. I have tried tightening it but unsuccessful.
My postcode is BA3 4JL, west of Radstock in Somerset. Hopefully a plumber would like the job - social distancing guaranteed during the job!
Click to expand...

Plumber found, please cancel posting, thanks.
 
Last edited:

Reply to Gledhill inlet control valve leaking on pressurised system in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

F
Mystery Mira Elite QT Leak
Hi All I have a leak coming from within my Mira Elite QT shower. It seems to be flowing from behind the switching Control. Any ideas what could be causing this leak. Already Changed the Pump Elbow as one of the clips had popped which was causing a second small leak, Any idea? Is it time to buy...
Replies
0
Views
229
Firefox
F
N
Towel Rail Valve Advice please (35 Characters needed.)
I have had a look at previous posts and think I know the answer to this but just before I make it worse could I just check what you think about this one. Granddaughter just moved house and this valve decided to leak when it was closed. When open its fine. Normally I have repacked the gland on...
Replies
7
Views
179
Timmy D
T
S
Advice needed for a mixer Spray for kitchen ?
Hello plumbers in my internet. So the Mrs want a spray mixer tap in the kitchen as we had two separate taps. I changed the tap for a temporary two hole mixer but the cold water pressure is high mains fed and the hot is low pressure immersion tank fed. I've been trying to find info on what I...
Replies
2
Views
97
Lou
Lou
D
Extending outdoor tap and drain
Hello all, I'm would like to extend an existing outside tap to another point in the garden. I'm about to pour a concrete patio and was hoping to run the water line underneath. There are existing drain (and who knows what) pipes running along the same wall so I'm nervous about digging too far...
Replies
6
Views
224
DIwhYdidIstartThis
D
D
UK Can't get stopcock 100% closed to allow a tap repair
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Replies
1
Views
235
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock