Discuss How do I remove this quarter turn ceramic valve? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
- Messages
- 34,343
- Solutions
- 2
The shroud will undo eg the brushed stainless
Thanks Shaun. Will there be another fixing to undo for that somewhere as I cannot seem to find one?
- Messages
- 34,343
- Solutions
- 2
No should just unscrew might be tight as normally gets stuck with scale etc
That’s off now! Thank you so much! I am shocking at anything DIY so it’s been great to get such a quick response to this.
Reply to How do I remove this quarter turn ceramic valve? in the UK Plumbing Forum | Plumbing Advice area at PlumbersForums.net
Similar plumbing topics
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
I have attached an image of the brass body within a tap. Having replaced a cartridge which has cured a leaking tap, I can see that there is a small leak from the brass body which can be unscrewed.
Is there a seal behind the body?
Thanks.
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
I have a plumber coming tomorrow to change a cartridge on a badly dripping tap on my bathroom mixer unit. There is no separate isolating valve for this tap so I'll have to close the stopcock. I tried closing it today but it won't go absolutely 100% closed and there is still a very slight flow...
Hi all I'm hoping someone can shine a light on this for me
Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall)
Unfortunately turning this to the closed position only reduces...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
-
Running copper pipework above / across a Gas boiler?
- Started by kristeva
- Replies: 2
-
Installing pipework to avoid airlocks
- Started by Matt0029
- Replies: 1
-
DUK Pipes for thermostat shower fitted at different heights
- Started by Delforkids
- Replies: 2
-
-
-
SPorcelanosa KRION Attica screen 1.2m, anyone?
- Started by Sebastian T
- Replies: 0
-
Cistern filling one third of the way
- Started by dwaindigital
- Replies: 4
-
Boiler losing pressure only on central heating- Started by SnosRap75
- Replies: 6
-
tanking. Is it ok to just seal everything with plastic.
- Started by Staggersandfalls
- Replies: 3
-
Pop quiz, does anyone recognise this radiator valve?
- Started by dimuc
- Replies: 4
-
SUsing coil to clear pipe leading to gutter
- Started by Sonya K
- Replies: 2
-
Replacing outdoor P-Trap Gully with Bottle Gully
- Started by DIwhYdidIstartThis
- Replies: 0
-
-