Ideal Independent C24

[kb76]

Hi, been to one of these this morning which looks no different to a Logic badged up different. Upon power up on spur with boiler selector switch in off position it's still going through its first stages of demand bar ignition then get L followed 2. Manual points to board or gas valve, getting correct resistance across furthest pins on valve. Anyone else had this on one of these?

 

[quality]

ignition electrode, spark generator and lead or a bad earth

 

[kb76]

Thanks quality. What's causing it to come to life when selector is in the off position?

 

[kb76]

Update. Found the isolator spindle had sheared off on PCB. Although the knob was springing back after resetting it wasn't actually resetting the boiler hence the last fault code L2 still being displayed, tenant has token meter and must have run out of gas...arrhh! New knob and running again...