Search the forum,

Discuss Towel Rad on DHW in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
Not uncommon on larger installations with pumped secondary hot water circuits ,must be made of correct materials of course,copper,brass,see a lot in the old flats in mansion blokes were hot water is communial ,boiler and cylinder in basement and hot water secondary circuit is just gravity,rising through main riser to outlets and towel rails next to riser
 
Could you install the rad on the primary circuit feeding the cylinder?
 
How would you know if towel rail was on h/w circuit apart from chasing the pipework.
I suppose if you drained the heating circuit and cracked the towel rail nut and it was still full theres a chance it could be on the h/w circuit.
 
If you turn the boiler off and the radiators go cold, if the towel rail stays hot then its on the hot water side unless it has the duel fuel element in and that is switched on, if it goes cold as well then its on the primarys
 
Actually not that easy,as firstly you may not be looking for it

We are talking about towel rail being on Domestic hot water secondary return system so getting heated with water out of cylinder

So you would have to turn radiators and hot water off,let pipe work cool down and if water in cylinder hot, towel rail will stay hot,but maybe, just as you turn everything off ,timer on DHW pump goes off, as per sods law and were are you

Many have drained a system and not thinking broke the joint on a valve to a towel rail only to find water poor out,causing puddles everywere :) and angry porters chasing after you
If you install one or come across one,always good to put label near boiler or cylinder informing plumbers in future

But basically if you see secondary return from cylinder ,maybe a clue or if in a old portered block,check with porter
Beware of towel rails in the larger properties
 
Last edited by a moderator:
Status
Not open for further replies.

Reply to Towel Rad on DHW in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

Hi, My current hot water system needs to be replaced. Anyone got any suggestions or can recommend any plumbers around Derrimut area that won't rip me off? An office guy recommended me to apply for government rebates and get it installed through timetosave.com.au. How reliable is this...
Replies
6
Views
267
Our kitchen mixer tap has started dripping. Like so much of the plumbing in our almost new build bungalow, it is lacking! The plumber didn't install any isolating cocks in the H&C feed to the tap so how can I identify which of the valves is passing? Shut the whole H&C water system down?
Replies
8
Views
250
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
276
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
209
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock