Search the forum,

Someone to fit a potterton paramount four 30kw boiler

Discuss Someone to fit a potterton paramount four 30kw boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

D

Dr John Doolittle

Messages
19
Looking for someone experienced in fitting potterton paramount four 30 boiler. I want to use the boiler features for DHW, external probes and secondary heating circuit rather than it being plumbed as just another dumb boiler (there must be a pun in that). I'm in the Northeast
 

Reply to Someone to fit a potterton paramount four 30kw boiler in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
176
exedon2
exedon2
T
22mm MDPE connection
I want to reconnect some outbuildings to an existing water supply. The supply pipe is old 22mm MDPE and buried for a fair distance so not going to dig it up and replace it 😬. Question is can I use normal 22mm plumbing push-fit connectors to make the connection as finding 22mm MDPE fittings...
Replies
1
Views
224
ShaunCorbs
ShaunCorbs
F
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
We run a community village hall and have a large kitchen provided for the use of hirers. This includes a Lincat SLR9 gas cooker which I believe is a 23.8Kw appliance with all six burners and oven on max. This was installed some 10 years ago and has passed all subsequent Gas Safety inspections as...
Replies
3
Views
200
Last Plumber
Last Plumber
A
copper vs pushfit pipes
Copper pipes, I think its fair to say, is not what it used to be, the copper is getting thin while the cost is going up. Meanwhile, plastic Pushfit seems to be getting better and better, cost and convenience was always better, but now the quality is to, have we reached a stage where plastic will...
Replies
2
Views
181
Chuck
C
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
117
ChrisGid
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock