Just thought I would update from previous post if anyone interested, above boiler had ignition fault, though I got up early and watch boiler until fault occurred right after some gurgling sounds so basically ran HW and CH for a couple of hours, never heard anymore noises and has had no faults since so I'm guessing air has managed to escape via vent . Happy days.
- Thread starter jrmroxx
- Start date
- Replies 1
- Views 1K
- potterton potterton suprima suprima update
Discuss Potterton Suprima 50L update in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Reply to Potterton Suprima 50L update in the Plumbing Jobs | The Job-board area at PlumbersForums.net
Similar plumbing topics
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking?
This originally happened about 12 months ago and has happened 3-4 times since.
It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
I was stupid enough not to check the position of the pipes under the tiles when installing a toilet and drilled right through the center of a 16 mm copper water pipe. I exposed the pipe by removing a ~30cm section of the plastic sleeve and a ~10 cm section of the pipe around the hole. Several...
Creating content since 2001. Untold Media.
Newest Plumbing Threads
-
What constitutes a Commercial Appliance and thus a Commercial Kitchen?
- Started by FozzieBear
- Replies: 3
-
POTTERTON PROMAX 28 COMBI Boiler - Hot Water Issue
- Started by boiler101
- Replies: 4
-
Hole in copper pipe, solder under floor, T coupling & protection
- Started by dreikher
- Replies: 0
-
-
-
-
-
-
-
-
-
Sewer pipe problems not sure about it- Started by sammie81116
- Replies: 3
-
-
-