Search the forum,

Ideal isar HE30 boiler leaking from the diverter valve manifold

Discuss Ideal isar HE30 boiler leaking from the diverter valve manifold in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
A

anthony

Hi all
i have the above boiler thats now in its 14th year of service .Now i know these things dont have a good reputation but i have to say this one has been relatively trouble free till now .Only last week i noticed a steady drip and after a little exploration i worked out its coming from the diverter manifold so what i want to know is could i fix this myself .Forgot to say the boiler is working as it should its just leaking [occasional drip ]and i have to top it up every couple of days.I have done some plumbing over the years [bathrooms new kitchens ect]
cheers Anthony
 
You have to be gas safe registered to work on that, as it is a gas appliance.
You need to contact a gas safe registered Engineer.
If you go onto the Gas Safe website, it will point you in the direction of Engineers in your area.
Hope this helps.
 
same as the last plumber said you have to be a gsr even to take the casing off the boiler it can be potentially dangerous get a gsr engineer to sort it
 
Status
Not open for further replies.

Reply to Ideal isar HE30 boiler leaking from the diverter valve manifold in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

J
Diverter Valve / No Heating Help
Hi,

 Our heating stopped working today. We've got a Veissmann boiler that's under a year old, and an older Megaflow cylinder, and two diverter valves (all about 10 years old). We also use a Hive thermostat.

 When I boost the hot water with Hive, the receiver near the boiler shows it's...
Replies
1
Views
654
exedon2
exedon2
Martdj
ideal Isar He30 boiler works but the contol panel appears to be dead
I have an ideal Isar He30 ( yes I know they are crap!) the boiler works but the contol panel asppears to be dead, the DHW and CH temperature controls have no effect and the boiler runs at max temp on both DHW and CH. I have repalced the display/contol panel and it still appearsto be dead. Would...
Replies
6
Views
906
cjg
C
S
No heating flow. Pump and diverter working, what else could be wrong?
Hello all, I have a WorcesterBosch Greenstar 42CDi classic combi, which is providing DHW fine, but not heating. Was working fine in spring, probably not been used until recently now it's colder. When heating is called for, the boiler fires up ok but soon shuts down the heater as the...
Replies
11
Views
963
Stupot
S
A
Looking to replace Honeywell Diverter Valve on pressurised system
Hi The area is near Telford in Shropshire. I have a 25 year old system. A gas fired Rayburn heats hot water and CH. The Honeywell diverter valve (the silver box thingy) has failed on the CH side, but I still have hot water. I bought a replacement, the Honeywell bit, connected to the 3 way...
Replies
0
Views
680
Alan Hayward
A
TeddySam154
Boiler has started leaking water urgent advice needed?
Hi, I need some urgent advice. I've Just come home after going out for evening, to discover hallway floor and kitchen floor covered in water. On further inspection I discovered that water was coming from boiler cupboard. On looking in boiler cupboard I found boiler has started leaking water...
Replies
1
Views
483
SimonG
SimonG
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock