Search the forum,

High FGA Readings

Discuss High FGA Readings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Status
Not open for further replies.
M

mrmills

Working on a glowworm flexicom 18hxi today and I had the following results :
02 - 4.2%
C0 - 1716 PPM
Ratio - 0.0180
C02 - 9.5%

It is only 3 years old, gas valve has been reset as per manufacturers instructions and tried two anaylsers in case was faulty. Any suggestions ??
 
You'll have to mail one of the mods to get a bit of advise in the GS reg forum
 
I know what the problem will be, but you need to get in the private gas safe forum, pm one of the mods for access. I hope you didnt leave the boiler running.
 
No I ID it and capped it. How do I get into private forum ? Sorry new to this and heading back to property tomorrow. I have ordered up new gas valve and was going to head back and clean main burner but manufactuer said unlikely dirty to that extent after 3years.
 
I have just unearthed this thread and have the same problem with an Easicom, I'll try and get myself registered for the private forum...
 
Status
Not open for further replies.

Reply to High FGA Readings in the Plumbing Jobs | The Job-board area at PlumbersForums.net

Similar plumbing topics

johndave
Outdoor stopcock doesn't fully close
Hi all I'm hoping someone can shine a light on this for me Since our stop tap on the pavement has now been filled with sand for whatever reason, we are relying on our property fitted stopcock (this is outside on our garage wall) Unfortunately turning this to the closed position only reduces...
Replies
3
Views
176
exedon2
exedon2
C
Mixer bar fitting solutions?
The fittings below are for a mixer bar attached to a self contained shower. i.e not a wall. The attaching screws have snapped. I could get two new brackets, dismantle that existing one and start again or I could try and re attach via those screws, removing the broken ones from the plate and wall...
Replies
0
Views
117
ChrisGid
C
P
Repeated Airlock in Bathroom
Hi, Can anyone advise as to why the cold water to my bathroom keeps airlocking? This originally happened about 12 months ago and has happened 3-4 times since. It’s an upstairs bathroom, fed from a tank in the attic. The tank is about 8 Meters away and feeds a bath, sink and toilet. The tank...
Replies
9
Views
256
Chuck
C
Creating content since 2001. Untold Media.

Newest Plumbing Threads

Back
Top
AdBlock Detected

We get it, advertisements are annoying!

Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.

I've Disabled AdBlock