I'll pop this into the general advice forum as it seems the most active, but mods - feel free to move if there's somewhere more appropriate. Thank you!
---
Apologies, but yet another "boiler losing pressure" thread - I've read many others, but am no closer...
Not my boiler (parents), so...
Looking for some help here - not my boiler, so consider me a proxy. I'm also by no means a heating engineer: I'm just looking for pointers, as the owner of this boiler is now caught firmly between "not us", "not us" and "not us" - nobody will take responsibility, and just calls into question...
Hello guys!
I had an Ideal Combi Logic+ C24 fitted in August 2021 in my mid terraced house and I started noticing that it was losing pressure during winter 2021.
I had the first engineer sent by Ideal in March 2022 when the pressure was going down very fast, I could see the gauge going down...
Hi all. Our Ideal Isar combi boiler wasn't igniting, so we had a plumber come out during the week to fix it. He said it was a dirty spark electrode (at least I think that's what he called it), so he fixed it and the boiler started working again.
However, since then our water doesn't get...
Hello,
I hope somebody can help with this - I've just been trying to reset the service reminder on my Ideal Logic Combi Esp1 35 boiler. In the end, I was told to go into installer mode. When I got to the Service bit, right at the end, pressing 'restart' brought up a list of numbers to cycle...
The main circuit board has gone 3 times in the last 3 months after heavy rain. I have a maintenance contract with British Gas but they will not keep replacing the board FOC. How can I stop his happening? The boiler is 7 years old and I have not had this problem until recently so what will have...
Ideal Combi bolier. When I repressurise the system to 1bar it almost immediately dumps the water out the condensate pipe before even switching in on at mains. HELP!
Hi all. Daughter's boiler again thanks for help last year.
New problem - hot water works fine, but when calls for heat boiler starts and runs for a few seconds then stops. No error messages.
My thought is that pump is inop, so boiler starts up but then switches off when the small amount of...
Been out the trade now for sometime now, a little out of touch with the latested boilers.
I have a problem with my Ideal 30 combi boiler as follows.
Heating is fine, no hot water so replaced the turbine now working fine but the pre heater is not working and no fault codes given. Any advice...
Hi, I had an Ideal C30 combi fitted about two months ago and I have noticed that it sometimes loses a really small amount of pressure. I fill the loop until it is on exactly 1 bar and sometimes when I look at the gauge it has dropped about 1mm below and then another day it will be back up to 1...
Hi, I live in Dartford Kent.
I have a ideal combi boiler which is roughly 6/7 years old. When the hot water is on and I run the hot water the pipes to Immersion tank make a loud vibrating burping noise. Any ideas what the issue would be?
Hi all,
First off, I'm just a homeowner looking for advice, I'm not a gas engineer.
On Friday I had smart meters installed and 5 times since then (never previously), the 3-year-old Ideal Logic + Combi boiler has made a fairly loud humming/vibrating noise while running hot water for a few...
Hi
I have a Ideal Combi 35 boiler, we are getting CH but not HW. I have been looking around and seem to think it’s the diverter valve.
Any suggestions would be great fully appreciated.
Cheers
Hello everyone, I hope you can help..I'm a total dunce when it comes to all things plumbing, apologies if posted in the incorrect forum too! Sorry this post is going to be quite long/descriptive but I was just hoping to get a second opinion on the methodology the plumber used to fix our boiler...
Hey all,
After a search on the forum i couldnt find anything so though id ask you kind souls.
After installing Drayton Wiser smart thermostat and TRVs to the Ideal Logic + 35, the CH temp doesnt get above 45degrees.
The boiler itself has a temp dial which will go from 45-83degrees for...
Hello
Yesterday I noticed that the boiler is displaying an f1 error. I have bled all radiators and checked the pressure, it is just above 1 bar.
Can anyone suggest what else I could try please. Thanks in advance
Hi all,
I've just moved in to a new build with the above boiler and two thermostats (one upstairs, one downstairs). The other day we had an issue where the heating upstairs stayed on no matter what the thermostat said, I managed to factory reset the upstairs thermostat and since then the rads...
Hi all - looking for some quick advice and all opinions welcomed!
Question: Is it really possible for a 3 year old new build flat Ideal Combi 35 to have "Multiple component failure due to poor water quality - drain down & powerflush required to inhibit future related issues, which are now...
Sure, ad-blocking software does a great job at blocking ads, but it also blocks useful features of our website. For the best site experience please disable your AdBlocker.